Home > IP Routing 2

IP Routing 2

May 12th, 2017 Go to comments

Question 1

Question 2

Explanation

The administrative distance of each protocol is compared to see if that route is better or not.

Question 3

Explanation

Letter “D” is used to symbolize for EIGRP (with a default AD of 90). Letter “E” is not used for EIGRP because it has been used for Exterior Gateway Protocol (EGP). It is a obsolete routing protocol now.

Question 4

Question 5

Explanation

If there is a default route then surely the router will forward all unknown traffic to there. But if there is no default route in the routing table then the router will discard the packet. In this question we suppose there is no default route in the routing table. Otherwise the question should state it (this question is unclear).

Question 6

Question 7

Question 8

Explanation

Making a forwarding decision actually consists of three sets of processes: the routing protocols, the routing table, and the actual process which makes a forwarding decision and switches packets. The longest prefix match always wins among the routes actually installed in the routing table, while the routing protocol with the lowest administrative distance always wins when installing routes into the routing table.

routing_process.gifReference: http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html

Question 9

Explanation

In fact this question is not clear. If we understand that “router is unable to find a known route in the routing table” and there is no default route in the routing table then the router will surely discard the packet -> A is correct. But we are not sure if there is a default route or not so let learn more about gateway of last resort.

A Gateway of Last Resort is a route used by the router when no other known route exists to send the IP packet. For CCNA level, when ip routing feature is enabled, a gateway of last resort is usually created by:
+ The “ip default-network” command (but dynamic routing protocols have different behaviors). But in general, the “ip default-network” cannot set the gateway of last resort without a known route in the routing table.
+ Creating a static route to network 0.0.0.0 0.0.0.0 is another way to set the gateway of last resort on a router. This is the reason why this question is not clear as it does not tell us if a default route exists or not.

Maybe in this question a default route does not exist. Otherwise the author would notice and indicate it in the question.

For more information about Gateway of Last Resort, please read: http://www.cisco.com/c/en/us/support/docs/ip/routing-information-protocol-rip/16448-default.html

Question 10

Explanation

The default administrative distance value of static route is 1 which is always smaller than any dynamic routing protocol so it is always preferred to dynamic routing protocols.

Question 11

Explanation

Floating static routes are static routes that have an administrative distance greater than the administrative distance (AD) of another static route or dynamic routes. By default a static route has an AD of 1 then floating static route must have the AD greater than 1. Floating static route has a manually configured administrative distance greater than that of the primary route and therefore would not be in the routing table until the primary route fails.

Question 12

Explanation

A host route for IPv4 has the mask /32, and a host route for IPv6 has the mask /128. If an IPv4 address is configured with a mask of /32 on an interface of the router, which is typical for loopback interfaces, the host route appears in the routing table only as connected (for example in the routing table we will see this line: “C 10.10.10.1/32 is directly connected, Loopback0”.

Reference: https://www.cisco.com/c/en/us/support/docs/ip/ip-routing/116264-technote-ios-00.html

Question 13

Explanation

If the IP address exists in the routing table then we can say the local router knew the way to reach that destination. But this question wants to ask if the destination has communicated to the local router or not (“an IP address is known to a router”). Maybe it is a tricky question.

Comments (39) Comments
  1. Chad
    June 13th, 2017

    Passed with the 747q dumps, all questions were from there.

  2. Yammato
    June 13th, 2017

    Question 7
    If a route is not present in the routing table for a particular destination, what would the router do?

    If there is no route in the routing table the router should not discard the package? For at no time the enunciation of the question signals the present-day representation of a standard route. What if a default route was not configured on this router? The right thing would be to dispose of the correct package?

  3. Becky
    June 21st, 2017

    Question 9
    Answer should be D

  4. Anonymous
    June 24th, 2017

    Can you please give the link for the 747q dumps

  5. OSC
    June 26th, 2017

    In Q8 When a device learns multiple routes to a specific network, it installs the route with?

    The response longest bit match (highest subnet mask) is not correct because it sais ” it installs the route with?” not which route the router choose. If the router are installed allredy, the router choose the longest prefix match, but if it has to install a new route, it will install the one with the best AD.
    So best suitable response will be B Lowest AD.
    What do you think?
    Does anyone agree?

    Acording to: http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html
    Making Forwarding Decisions

  6. JD
    June 26th, 2017

    Agreed to OSC. 9tut please correct. Thank You.

  7. JD
    June 26th, 2017

    Q8 is about installing the route in routing table not choosing a route from the routing table to route the packet.

  8. JD
    June 26th, 2017

    @Becky: And what if the router has no gateway of last resort configured? The question does not say anything about it.

  9. OSC
    June 27th, 2017

    And respect to Q5&9 at last we can make it at head or tail, it’s an anbiguos question and depends on how luky you are.
    Wha Q5 D and Q9 A?
    Why not the opposite?
    I don’t know, toss a coin and good luck!!

  10. @Anon
    July 8th, 2017

    I think in start configuration in routing table you don’t have any default of last resort.
    We should also point if router didn’t found any match means that you don’t have any Default Gateway, because if it exist we will not give information “router unable to find know destination”

    ip route 0.0.0.0 0.0.0.0
    0.0.0.0 any adres
    0.0.0.0 any mask

  11. Anony
    July 12th, 2017

    I agree with the above comments that say that Q8 is B.
    The device learns about multiple routes to a network and must choose one to install – it’s not choosing an already installed route to use. It’s installing a new one. So it will use the lowest AD.

  12. db
    July 13th, 2017

    Hi all,

    Can you send me 747q dumps on dblagojevic988 @ gmail. com ?

    Thank you!

  13. Arun
    July 18th, 2017

    Hi all

    Can you guys please send me 747q dumps to {email not allowed}

  14. Arun
    July 18th, 2017

    arunkrish666 @ gmail .com

  15. Salman
    July 22nd, 2017

    Please share 747q to salmankhan741 @ yahoo. com

  16. nickaro
    August 12th, 2017

    In Q.5 the supposed correct answer is D, but the explanation says the correct anser is B. What’s the right one? In my opinion is B.

    By the same reason in Q.7 te correct answer must be C.

    At no time, it is said the there is a default route configured. So, packets must be dropped.

    On the other hand, in Q.9, exactily the same case, the correct answer points to A (discard packet)

    Any opinion about ??

  17. nickaro
    August 12th, 2017

    I totally agree with you about Q.8, OSC.

    9tut please correct. Thank You.

  18. 9tut
    August 12th, 2017

    @nickaro: Thanks for your information. For Q.5 we have just updated the correct answer to B. Maybe in this question there is no default route, otherwise it should be clearly state.

  19. coco
    August 14th, 2017

    The Question 8 should be the lowest AD (Administrative Distance), in fact @9tut copied the link and the links says the lowest AD, so please fixed, we paid for it.

  20. manoj
    August 16th, 2017

    Hi all
    Can you guys please send me 747q dumps to
    tiwarimanoj50 @ gmail .com

  21. Anonymous
    August 30th, 2017

    hi all, kindly send me 747 dumps to hugo.nguyenthomas @ gmail.com

  22. Brainiac
    September 1st, 2017

    Q5 answer is D.
    Q7 answer is C.
    Q8 answer is B.
    Q9 answer is A.
    Read up here: https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html

  23. Brainiac
    September 1st, 2017

    Q5 answer is D. cos the question specified “destination NETWORK”
    Q7 answer is C. cos the question specified “PARTICULAR destination”
    Q8 answer is B. cos the question asks for what gets installed.
    Q9 answer is A. 9tut answered this one correctly.
    Read up here: https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html

  24. anon
    September 10th, 2017

    I think question 6 should be D.

    If two routes have the same AD then the metric would be used correct?

  25. anon
    September 10th, 2017

    q5 explanation does not match with question

  26. anon
    September 10th, 2017

    None of the explanations after Q5 match with the question

  27. Yemi
    September 15th, 2017

    Please help me send the dumps to {email not allowed}
    Thank you

  28. Yemi
    September 15th, 2017

    Please help me send the dumps to amurelove @ yahoo . com

  29. Preeti
    September 21st, 2017

    what indicates metric in output of “sh ip route”?
    D 1.1.1.8 [110/24534] via 1.1.1.13, 00:10:04, FastEthernet0/0
    Ans: 24534

  30. Peppino
    September 23rd, 2017

    Someone can send me all the dumps? I’m trying to take the exam on oct 16 . tnx to all (derath(at)hotmail.it)

  31. Anonymous
    October 4th, 2017

    hi all, kindly send me 747 dumps to {email not allowed}

  32. question 5, 7, & 9
    October 13th, 2017

    9tut you are not consistent. These 3 question are asking the same thing and they all DO NOT say that there is a default route, so the answer for all 3 should be discard the packet. This not the case, discard the packet is the answer for 2 and the 3rd answer is default route, but none of the questions state that there is a default route. Please verify the question and then provide the correct answer or a better explanation for the answer.

  33. 9tut
    October 14th, 2017

    @question 5, 7, & 9: We are sorry for the problem. The answer for Q.7 should be Drop. Thanks for your detection, we updated that question!

  34. nabil
    October 17th, 2017

    @9tut, can you check Q8?
    Answer A: the question is about selecting which route to install not select from routing table.
    Answer B: Most likely, if we assume different routing protocols.
    Answer C: AD takes precedence if we assume different routing protocols.
    Answer D : load balancing is treated differently for each protocol.

  35. 9tut
    October 18th, 2017

    @nabil: Yes, the answer for Q.8 should be AD. Thanks for your detection, we have just updated that question!

  36. Milan
    October 23rd, 2017

    Could someone send me 747q exam, please? miki.bozinovic94 @ gmail dot com

  37. Bhagya
    October 24th, 2017

    can you send the 747q dumps to me too. {email not allowed}

  38. Bhagya
    October 24th, 2017

    bhagyaf@gmail .com

  39. Bhagya
    October 24th, 2017

    can you send the 747q dumps to me too. bhagyaf@gmail .com

Add a Comment