Home > RIP Questions

RIP Questions

May 10th, 2017 Go to comments

Note: If you are not sure about RIP, please read our RIP Tutorial.

Question 1

Explanation

“Enable RIP” is surely correct to configure RIPv2 but “enable auto-summary” is not recommended. Maybe there is another suitable option for this question (like “use ‘version 2’ command” or “Allowing Unicast Updates for RIP”).

Question 2

Explanation

To enable RIP surely we have to enable it first (with the “router rip” command in global configuration mode) -> E is correct.

RIPv2 sends its updates via multicast but in Nonbroadcast Multiple Access (NBMA) environment, multicast is not allowed so we have to use unicast to send RIPv2 updates -> D is correct.

Question 3

Explanation

The split-horizon rule states that “a router never sends information about a route back in same direction which is original information came”. This rule is used in distance vector protocol (like RIP or EIGRP) to prevent Layer 3 routing loop.

Question 4

Explanation

A passive-interface with RIP prevents that interface from sending RIP advertisements but it is still receiving RIP updates from other RIP neighbors. This behavior is different from EIGRP and OSPF where the passive-interface statement stops forming neighbor adjacencies over that link.

Question 5

Explanation

Distance vector protocols (like RIP) exchanges the entire routing information each time the routers send the updates.

Note: EIGRP is considered an advanced distance vector protocol so it does not send the whole routing table for each update.

Question 6

Explanation

The difference between RIPv1 and RIPv2 is RIPv1 is a classful protocol (no support for VLSM or CIDR) while RIPv2 is a classless protocol (which supports VLSM and CIDR). Therefore in this question if we forget to enable RIPv2 then the router will use RIPv1 and it only advertise major network 172.16.0.0/16 to other routers. By enabling RIPv2 (via the “version 2” command) the router will advertise two subnets 172.16.10.0/27 & 172.16.10.32/28.

Comments (9) Comments
  1. kolaypu
    February 7th, 2017

    use version 2 command

  2. Star
    February 21st, 2017

    Version 2 command is compulsory to enable RIPv2

  3. Star
    February 21st, 2017

    Enable RIP command will only enable RIPv1 by default..
    So, Version 2 command is compulsory to enable RIPv2

  4. Anonymous
    February 26th, 2017

    use version 2 command

  5. Networkawy
    March 7th, 2017

    Use Version 2 Command
    Enable Auto-Summary with RIP V.2 is not Recommended if there subnet in Networks

  6. Brooks
    June 13th, 2017

    Passed today, used the 747q dumps. you can find them on https://drive.google.com/open?id=0B5mAFqgydmCzc3BmR214LWFuTDg

  7. idiott
    July 16th, 2017

    @BROOKS
    that link only appeared 10 questions what about remaining ??
    pls provide full version it came only demo version..

  8. anon
    September 10th, 2017

    Question 6 is missing the exhibit.

    I just made a guess and was right.

  9. khan
    September 11th, 2017

    marks4sure is fake site all the question involved in their dumps are with incorrect answers
    try to refers some other sites

Add a Comment